![]() This is not currently the case as the subsystem could still be running. Ubuntu), modify the configuration file, close the distribution, and then re-launch it, you might assume that your configuration changes have immediately gone into effect. This typically takes about 8 seconds after closing ALL instances of the distribution shell. You must wait until the subsystem running your Linux distribution completely stops running and restarts for configuration setting updates to appear. The 8 second rule for configuration changes Check which version of WSL you are running. WSL 2 runs as a lightweight virtual machine (VM), so uses virtualization settings that allow you to control the amount of memory or processors used (which may be familiar if you use Hyper-V or VirtualBox). WSL 1 and WSL 2 run with different architecture and will impact the configuration settings. wsl.conf to configure local settings per-distribution for each Linux distribution running on WSL 1 or WSL 2.īoth file types are used for configuring WSL settings, but the location where the file is stored, the scope of the configuration, the type of options that can be configured, and the version of WSL running your distribution all impact which file type to choose.wslconfig to configure global settings across all installed distributions running on WSL 2. You can configure the settings for your installed Linux distributions that will automatically be applied every time you launch WSL in two ways, by using: What is the difference between wsl.conf and. This guide will cover each of the settings options, when to use each file type, where to store the file, sample settings files and tips. wslconfig files are used to configure advanced settings options, on a per-distribution basis ( wsl.conf) and globally across all WSL 2 distributions (.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |